Hello everyone, I'd like to report the technical summary in Melbourne for 3 month.
I graduated ELSIS(English school), and finished the working at headquarter. Every one who works at headquarter is really kind and taught me various things.
Especially about technical skills, I learnt about basic one from Colin and Denis.
I mainly learnt:
(1) PDI(Pre Delivery Inspection)
(2) How to replace brake pads
(3) Install toe bar
I'd like to report these 3 things.
(1) PDI(Pre Delivery Inspection)
In these 3 things, I did it the most of all.
First, check there is damage or not, and check other things what are light and monitor etc.
When you finished to check all things, the last task is washing the car. In that case, you really have to wash it properly, more than usual.
(2) How to replace brake pads
Replacing brake pads are not really difficult,
First you take a bolt of bottom.
Then, raise the caliper brackets.
The new pad is really different from old one, means the old one worked a lot.
After installation of new pads, you have to return a piston.
The piston appeared. If it isn't returned, you can't install the pads properly.
You can push the piston by water pump pliers and a flat thing( I used an old pad this time)
It returned perfectly.
And then, returned the bolt what you took off first.
Finally, you conform the brakes work or not.
(3) Install toe bar
I could help this task only half way because it was difficult for me. But I did it many times.
I did these 3 things many times for 3 month in Melbourne, I can't forget the task and lots of memories.
Thank you.
